| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN KEY TO TURN OFF POWER TO VAC MOTOR
|
| 2 |
|
LOCATE CHARGER PLUG ON THE BACK OF MACHINE AND PULL TO DISCONNECT IT
|
| 3 |
|
RAISE COVER ON MACHINE TO LOCATE THE VAC MOTOR
|
| 4 |
|
USE THE PROP BAR TO PROP COVER OPEN
|
| 5 |
|
PULL DOWN ON THE FLOAT TO REMOVE IT
|
| 6 |
|
REMOVE THE 3 SCREWS HOLDING THE FILTER SCREEN TO THE COVER
| Torx T30 |
|
|
| 7 |
|
PULL TO REMOVE THE FILTER SCREEN FROM THE COVER
|
| 8 |
|
SECURE THE COVER IN AN OPEN POSITION. REMOVE THE SCREW HOLDING THE PROP BAR. REMOVE THE PROP BAR FROM THE MACHINE.
| Torx T30 |
|
|
| 9 |
|
PULL DOWN ON THE INSIDE COVER
|
| 10 |
|
IF YOUR MACHINE HAS A WHITE CONNECTOR BLOCK, REMOVE THE BLACK AND RED WIRES FROM THE WHITE CONNECTOR. CUT OFF BAD SECTION OF WIRE, THEN INSERT TRIMMED WIRES BACK INTO CONNECTOR BLOCK. IF YOUR MACHINE HAS SPADE ENDS, CUT TO REMOVE THE SPADE ENDS AND SPLICE NEW ENDS ON WIRES. IF LIMITED LENGTH OF WIRE, CUT OUT BAD SECTION AND SPLICE IN NEW WIRING USING WIRE NUTS AND ELECTRICAL TAPE.
| Screwdriver-flat tip |
|
|
| 11 |
|
REVERSE STEPS 2 THRU 9 TO REASSEMBLE MACHINE
|